Showerbond is a solvent based, fast grab, gun grade adhesive. It has been specifically formulated for bonding plastic shower linings to gypsum plasterboard or fibre cement wall linings, as well as timber.

Use Showerbond is used for bonding plastic shower linings to wall linings.

Advantages

 Fast curing.
 Will not damage plastic shower liners.
 Panels can be relocated for up to 30 minutes after positioning.
 Excellent adhesion to most common building materials.
 Easy to apply and clean up.
 Recommended for use with Seratone Silverseal, Clearlite Showers, Duracryl®
,and Athena Showers

Product Data
Form: Smooth paste
Colour: Green
Storage & Shelf Life: Twelve (12) months when stored in original unopened containers in a cool, dry place
away from naked flames.
Packaging: Showerbond is supplied in 300 ml cartridges.

Technical Data
Solids content: 65% approx. by weight
Cure type: Solvent release
Cure rate: 24 hours @ 20C
Application temperature: 5C to 35C
Skinning time: 1 minute
Relocation time: Up to 30 minutes, depending on temperature and ventilation
Flammability: Flammable solvents are released during cure
Toxicity: Non toxic when cured
Movement accommodation: Slight, will accept normal building movement
Coverage: On average, one cartridge of Showerbond will supply 20 metres of 5 mm bead.

Application Conditions
Surface Preparation Ensure both surfaces to be bonded are clean, dry and grease free. Cut nozzle on cartridge as shown below so that a 5-6 mm bead will be extruded.

Application

 Apply a 5-6 mm bead in vertical lines at 100 mm centres onto substrate, and apply continuous bead within 15 mm of the perimeter line of the shower lining.
 Place shower lining onto wall within 10 minutes and firmly press the entire sheet with your hands so that full contact is made with all beads of adhesive.
 Brace the lining as required in the shower manufacturer's installation instructions.
 Bracing if required should remain in position for not less than 18 hours. The shower should not be used for at least 24 hours after the wall lining has been installed. Do not apply blobs of adhesive. These will cause unsightly undulations and buckles in the sheet.