Selleys Wet Area Speedseal is an advanced silicone sealant technology that delivers a super-fast cure and stiff consistency producing a waterproof / shower ready seal in 1 hour*. Cured sealant is guaranteed to resist mould and mildew growth for 5 years#.

Features
Superfast cure and stiff consistency provide a waterproof seal to allow shower use 1 hour after application*.
Cured sealant is guaranteed to resist the growth of unsightly mould and mildew for 5 years#
100% silicone sealant
25-year guarantee** against crumbling, cracking or peeling away.
Superior waterproof seal
Built-in fungicide to inhibit the growth of mould.
Available in a range of colours to suit most wet areas.
Non-corrosive neutral cure formula.
Temperature resistance - approximately -60°C +150°C.

Where can this product be used?
Showers
Baths
Spas
Sinks 

What materials is this product suitable for?
Ceramic
Glazed and porcelain fixtures
Metal
Copper and brass fittings
Powder-coated Aluminium
Aluminium
Plastic laminates
Rubber
Glass
Stainless Steel
Concrete 
Not for use on polyethylene, polypropylene or Teflon. Pre-test plastics before use

Use in a well-ventilated area. Avoid contact with skin and eyes.

Thoroughly clean and dry surface from oil, dirt and grease with mineral turps. Allow to dry completely before applying silicone.
Cut the seal at the top of the cartridge, cut the nozzle at a 45° angle, to the size of the gap opening. Fit the nozzle to the top of the cartridge then insert the cartridge into a caulking gun such as Selleys Light Speed Caulking gun.
Hold the caulking gun at a 45° angle. Press the nozzle opening against the joint, apply with steady pressure, ensuring sealant is pushed into the joint. Important: Product will skin over in 5 min.
For a smooth finish, tool with a spatula dipped in detergent water within 5 minutes of application.
Clean up excess sealant before sealant skins (5 minutes) with mineral turps. 

Limitations:

Not paintable. Complete painting 7 days prior to applying sealant.
Not for use on polyethylene, polypropylene or Teflon. Pre-test plastics before use
Not suitable for building materials that bleed oils or solvents, such as impregnated wood
Not for aquariums or contact with food, eating utensils or drinking water 

For neater joints, mask sides before applying sealant and remove the tape before sealant skins.
When first applying product, extrude a small amount onto a piece of scrap material to ensure a smooth continuous flow of silicone sealant.
Work in sections that can be completed before sealant skins.
Tooling off and tape removal must be completed before skinning occurs or a rough surface may result so working in sections allows for a better finish. 

Clean Up
Uncured product may be removed with mineral turps.
Cured product can be removed with Selleys Silicone Remover or by
cutting and scraping.