Selleys EZI Press Liquid Nails Fast Action High Strenght Cartridge 130g
Selleys Ezi Press Liquid Nails Fast water based high strength construction adhesive is the NEW easy to use application system that does not require a caulking gun. Simply apply at the press of a lever. Perfect for sticking materials together such as architraves and skirting.
No caulking gun required
Easily applied with a press of a lever
Flow control for precise application and finish with no run on
Fast grab minimises slippage when adhering on vertical surfaces and minimises the need to support joints while it cures.
Water based, so it is faster to clean up. Less mess and fuss.
Low odour making it ideal for indoor jobs.
Heat resistant meaning the integrity of the bond will remain when exposed to direct sunlight.
Strong bond – which will cope with shrinkage and thermal movement, so you know the job will last.
Paintable after 12 hours.
Cures and works best on porous surfaces, which makes it ideal for sticking wall panels to masonry.
Doesn’t drip, sag or string, so there is less mess when you are using the product
Bridges gaps on rough and ill fitting construction material
Not for use on polyethylene, polypropylene, Teflon or silicone.
Perfect for indoor projects:
Timber panelling to walls
Styrene foam panels and blocks
Particle board to masonry surfaces
Tasks where nailing is not desirable
For sheet timber flooring to flat surfaces LIQUID NAILS High Strength is recommended.
Not suitable for use for polyethylene and polypropylene.
Bonds are not water resistant. Protect bonds from water penetration if used in exterior applications.
What materials is this product suitable for?
Rubber & Glass
Concrete and Masonry
Tiles and ceramics
Most plastic – pre test plastic to determine compatibility
How to use this product
Ensure the surfaces to be bonded are clean, dry and free from dust, grease, oil and loose powdery materials. If porous surfaces are greasy or dirty, we would recommend cleaning the surface with SELLEYS LIQUID SUGAR SOAP, and allow to dry. If the surface is non-porous eg metal, firstly clean the surface with Mineral Turpetine and then again with Methylated Spirits, and allow to dry. Surfaces should not be visibly wet or constantly damp. Oily timber types may need to be wiped with solvent prior to application to remove surface oils.
We also recommend sanding the surface back with a good quality sanding block, as the construction adhesive will adhere more readily to a scratched up surface.
Ezi Press remove cap
Remove tab lock and nozzle cap. Twist collar clockwise towards MAX and adjust between MIN and MAX to control flow.
Ezi Press application
Simply press lever gently to dispense filler to surface.
On broad flat surfaces apply beads every 40cm,
on smaller surfaces apply dots.
Bring surfaces together as soon as possible (within first 5 mins). Fix with sufficient nails, screws or clamping to hold load.
Ezi Press min max
Clean up with a damp cloth, twist collar back to
MIN and replace nozzle cap.
Allow the adhesive to set (at least 24 hours) before removing any temporary fasteners or clamping.
For higher initial grab, apply to one surface only, press together and pull apart. Allow to dry for up to 5 min (no longer) before firmly joining.
For porous substrates, a good bond strength is achieved after 24 hours and will continue to strengthen over a 2-3 day period. The time it takes to form a strong bond depends on the nature and conditions of the application. In cold or damp weather and between non porous materials, the drying time is greatly extended.
When the product is still wet it can be removed with warm soapy water or a damp cloth, otherwise if the product is dry it can be removed by sanding or scraping.
|Unit Of Measure||each|
More From This Category