Selleys Armour Flex No Slump Paintable Instant 465g [White]
Selleys ArmourFlex provides superior strength with instant grab and more flexibility than conventional adhesive/sealants.
Superior strength & instant grab
No primer required
Watertight seal with a 10-year guarantee*
Can be applied to wet or damp surfaces with excellent adhesion
Better curing and extrudability (>5°C)
Easily paintable with 2 coats of water-based paints after product skins in 60 to 90 minutes
Potable water approved AS/NZS4020 (Area to volume ratios
**Meets GBCA limits for general purpose and architectural sealants.
Where can this product be used?
Expanding joints in concrete
What materials is this product suitable for?
Most plastics (Pre-test before use. Not for polyethylene, polypropylene or Teflon.)
Ensure substrates are clean and free of oil, grease or loose particles.
Cut seal and nozzle and fit to cartridge, then place in caulking gun.
Hold caulking gun at 45° angle and gun sealant ahead of nozzle ensuring product is pushed into joint.
For neat joints, use masking tape on both sides of the joint and remove before skinning.
Tool with a soapy solution before skinning occurs.
For optimal joint design, use non-absorbent backing material (e.g. polyethylene backer rod) and appropriate joint width/depth. See technical data sheet for more information.
Not suitable on polyethylene, polypropylene or Teflon.
Not for permanent water immersion or below water-line use.
In dry conditions, surfaces can be misted with water to speed up cure.
Paint with water-based paint. A minimum of two coats are necessary to ensure proper wetting out the sealant surface
|Unit Of Measure||each|
Others Also Bought
More From This Category